(enter) to select the equipment from which to project. Projecting the Picture 1 Turn on both the unit and theĢ Press INPUT to display the input palette on the screen.ģ Select the equipment from which you want to display images. When you monitor and control the projector via the network, access the Setup page of the projector (page 39) via a Web browser and enable the desired control protocol. For settings of the computer, consult with the manufacturer of the computer. For details, refer to the computers operating instructions supplied with your computer. Set your computer to output the signal to only the external monitor. If you set your computer, such as a notebook type, to output the signal to both computers display and this equipment, the picture of the equipment may not appear properly. If the picture from equipment connected to the unit with an HDMI cable is not correct, check the settings of the connected equipment. When connecting an HDMI cable to the unit, make sure the V mark on the upper part of the HDMI input of the unit and the v mark on the connector of the cable is set at the same position. If you use other types of cables, 4K video may not be displayed appropriately. When adjusting the window position, do not touch the lens unit, otherwise your fingers may be pinched by the moving parts. Tip Whenever you press the button, the test pattern disappears. Then adjust to the proper position of the picture by pressing the M/m/ Press the PATTERN button repeatedly to display the Lens Shift adjustment window (test pattern). To make the picture smaller, press m/ <.ĥ Adjust the picture position. Then adjust the size of the picture by pressing the M/m/ Press the PATTERN button repeatedly to display the Lens Zoom adjustment window (test pattern). Never make adjustments by directly turning the lens with your hands, which may cause damage or malfunction to the unit.Ĥ Adjust the picture size.
When Test Pattern is set to Off on the Function menu, the test pattern is not displayed (page 33).Īdjust the lens by using buttons on the remote control or the control panel of the unit.
Installation menu, you cannot adjust the lens (FOCUS, ZOOM, or SHIFT) (page 35). Tips When Lens Control is set to Off on the Then adjust the focus of the picture by pressing the M/m/ Press the PATTERN button repeatedly to display the Lens Focus adjustment window (test pattern). 40 Confirming the InformationĮrror Handling Troubleshooting. Using Network Features Displaying the Control Window of the Using the Menus Operation through the Menus. 14 Selecting the Aspect Ratio According to 7 Connecting to Video Equipment or aĬomputer. 5Ĭonnections and Preparations Installing the Unit.
0 kommentar(er)
